MOVIES

Adventure Helicopters in LA have been involved in many motion picture projects in the state of California for years, including Hollywood productions. Adventure Helicopters uses the Tyler Camera Systems, with a middle mount configuration. Whether for a large film production, a video or still photography mission, we are capable of getting the aerial footage you need. At Adventure Helicopters, our priority is to get you the footage you want, safely, the first time. Adventure Helicopters has extensive experience in movie production work. We have the equipment, personnel to get the job done first time. Whatever your project, we can help you make your production a success. Let us know how we can serve your film production needs.

Projects:

Tyler Mount (Movies)

Nelson Tyler (founder) invented the Tyler Mount in the late 1950's. In recognition of his accomplishment, he was later presented with a Scientific and Engineering Award from the Academy of Motion Pictures, for the progressive development and improvement of the Tyler helicopter camera platform. In addition, he more recently received an Outstanding Achievement Award from the Society of Motion Picture and Television Engineers.

MiniGyro

Optimized for small size / weight cameras and lenses, the MiniGyro shoots from right or left side, and provides pan, tilt and roll; great for air-to-ground or air-to-air, and fast action sequences. Straight-forward shots can be made by crabbing the helicopter; up to @ 40 mph. The MiniGyro is ideal for use in helicopters as well as cars, boats, planes and hand-held shooting. Your Operator, your AC, and your camera package. The MiniGyro’s compact size and simplicty, makes it our most versatile, portable and cost-efficient piece of equipment, and is a superb still camera stabilizer too.

FAA STC approval not required

Setup & Safety Notes

1. Handle unit can fit on to MiniGyro four different ways. Most common is with the hand grips pointing upwards, next to the camera itself, with the handgrip lock knobs facing rearwards towards the operator.

2. Make sure handle unit lock shaft is snug into dimple on handle unit (small knob).

3. Make sure camera is tight to camera plate with proper allen screw.

4. Make sure camera plate, with camera, is locked into receiver on MiniGyro and safety latch is in upwards position.

5. Make sure MiniGyro shock absorber unit “snaps” into bottom of MiniGyro.

6. If operating from aircraft or watercraft, be sure “Y” tether strap is attached to both

MiniGyro and shock absorber and then secured to vehicle hard point.

MiniGyro Operation

The MiniGyro requires 3 pin 28 Volts DC input into right side receptacle. LED power indicator on left side: Green indicates correct voltage. Red indicates low voltage. IMPORTANT: MiniGyro “gyros” requires 20 minutes spin-up time before filming. IMPORTANT: In extremely hot conditions turn MiniGyro off between use to prevent gyro unit overheating.

SHOOTING NOTES: For best results hand hold MiniGyro (if possible) so no part of the MiniGyro is touching the vehicle, not even the shock unit. Use shock unit when long shots are required or the camera package is too heavy to hold MiniGyro up.

Tilt camera up or down on MiniGyro as needed for comfort depending on angle toward subject. Use black lock arm on left side of MiniGyro to lock tilt unit in place.

NOTE: Black lock arm can be d-tented to desired position by pulling arm out and twisting. Panning too quickly will cause gyros to go to gimbal lock. You will feel a jolt if this happens. Adjust panning rates according. The MiniGyro can also be used while walking, similar to Steadicam shot.

STABILIZATION: BRUTE GRYOS

POINT-OF-VIEW: SIDE (LEFT OR RIGHT)

MOVEMENT: PAN, TILT & ROLL

FOCAL RANGE: 18-250MM

MAX. CAM. WT.: 40 LBS.

INSTALL TIME: 2 MIN.

FAA - STC approval not required.

MIINIIGYRO™

FOR FILM & VIDEO